6 Best Wall-Mounted Patio Heaters in 2026

The hykolity is a 35.5 in wall-mount heater with a 1500W infrared system and dual carbon tubes. The maker says it delivers warmth in about a second, and the two-tube layout spreads heat from top to bottom of the unit. A remote control and a timer that runs up to 24 hours cover everyday control.

The listing makes a point of safety and weather sealing. It is ETL-certified, with three layers of protection including tip-over shutoff and an overheat safety cutoff. An IP55 rating means the housing is dust protected and resists water jets, and the aluminum housing is described as corrosion-resistant, which suits an uncovered patio.

At 1500W it matches the blessny, the Danluke and the sundate on power, so the decision rests on controls and certification, and the ETL listing is the clearest differentiator. It is less powerful than the 3000W DR-239 and ThermoMate, but it avoids the extra wiring those require. For most patios with an outlet nearby, it is the most balanced pick.

The DR-239 is a 3000W carbon infrared heater rated at 10,260 BTU, which is double the wattage of the 1500W picks. The listing says it delivers instant, clean heat with no waiting, and it is rated IP55 for indoor and outdoor use, so it suits patios, garages and workshops alike.

It ships with both wall and ceiling mounting brackets, so you can pick whichever surface suits your layout, and a remote lets you switch between power levels. The higher output makes it the strongest choice for a big patio or for people who sit farther from the unit.

The trade-off is electrical. A 3000W heater draws far more current than a 1500W unit, so check the listing for the voltage and confirm with an electrician that your circuit can support it. Compared with the ThermoMate, which is explicitly hard wired at 240V, the DR-239 is the better candidate if you want a high-wattage unit with simple brackets. Against the hykolity at 1500W, it gives double the power but demands more from your installation.

The ThermoMate is a 3000W carbon fiber infrared heater that runs on 240V and is hard wired. The maker says it heats in about three seconds and covers about 100 sq. ft. outdoors or 130 sq. ft. in an enclosed space. A remote switches between a 1500W low setting and a 3000W high setting and sets a timer up to 24 hours.

Because it is hard wired, it does not plug into a wall outlet, so installation is not a casual afternoon job. That is the main trade-off, and a licensed electrician should handle it. The reward is dependable high output with no extension cord, which suits a permanent patio setup.

Compared with the DR-239, which also offers 3000W, the ThermoMate is the better pick when you want a clear coverage figure and a deliberate low and high mode. Compared with the 1500W models, it covers a notably larger area. It is not the best pick for renters or anyone who might move, because the wiring stays when you leave.

The blessny is a 1500W infrared wall heater with a carbon fiber tube and an oxidized sprayed aluminum shell. The maker says it produces heat in about three seconds. A 6.0 ft cable and wall-mount hardware are included, and the listing mentions clear instructions.

Its best feature is the IP65 rating, one step above the IP55 of the hykolity. IP65 means the housing is fully dust tight and resists water jets, which is the stronger rating for a patio that sees rain or hose spray. The unit is run with a remote and a 24-hour timer, and the listing claims silent operation.

The 6.0 ft cable is practical but limits placement: the heater must be mounted within reach of an outlet, so plan the height and cable path ahead of time. At 1500W it is on par with the Danluke and the sundate. Against the hykolity, it gains a stronger water rating but does not list the same ETL certification, so safety-minded buyers should compare those two closely.

The Danluke is a compact 1500W wall heater using a carbon fiber element for focused warmth. It measures about 25.59 x 5.16 x 2.36 in, which is shorter than the hykolity at 35.5 in, so it fits tighter wall spaces. The maker describes the design as space saving.

Control comes from both a remote and a touch panel on the unit. Having both is handy: the remote works from your seat, and the panel works if the remote goes missing. The listing does not state a weather rating or a timer in the portion we reviewed, so check the full page before relying on it in heavy rain.

The shorter body means a narrower heating footprint than the 35.5 in hykolity, so it suits a pair of chairs rather than a long bench. It is a sensible choice for a small porch or a covered corner. Against the sundate, which also offers touch and remote control, the Danluke is the simpler listing, but it gives you fewer confirmed extras.

The sundate is a 1500W radiant wall heater with three heat levels and a carbon fiber tube. Heat is targeted, and the maker describes it as instant. You can control it from a touch panel on the unit or with the remote, and a 24-hour timer is included.

A waterproof design is listed for rain and moisture, along with dual safety protection, though the portion we reviewed does not give an IP number. That makes it harder to compare directly with the hykolity at IP55 or the blessny at IP65, so read the full listing to confirm the rating.

Three heat levels let you run it lower on mild evenings, which saves electricity and avoids over-heating a small seating spot. In practice, it is closest to the hykolity in feature set, with a similar timer and remote. If you want easy dual controls and a familiar layout, it is a dependable pick, but the lack of a stated IP rating is the main caveat.